It's been a weekend away for us so bench time has been pretty much non-existent. I've done a bit since we arrived home this afternoon but thought I'd post it up anyway.
As this is a later Lot jet there are a few panels that need be filled to make it up to date. Hasegawa kindly provide a diagram for the nose panels that need to be filled which is what I've done.
To fill the holes I've mixed up some CA and talc to make a material that's quite easy to sand. Mr Surfacer could probably do the job but as it dries it shrinks and leaves the filled areas still visible. This results in an added application and sometimes more depending on how big the area is. This mix of CA and talc has been around for a while and some manufacturers have even produced 'microballons' that act like the talc.
I've applied it with a toothpick on both areas of the nose which need correction. I'll hit them with some wet 400 once dry and then a scrotchbrite to polish to remove any sanding marks.
I've used the same CA/talc filler to fill on the seam join line on either side under the LERX. I wasn't happy with the Mr Surface particularly the shrinkage problem that I mentioned earlier. It does look a bit messy but will certainly clean up well without needing to worry about the filler shrinking now or later. I applied it with a toothpick but a bit less 'accurately'